If I load 'workspace 1' the Simple Desk works fine. But if I then load 'workspace 2', Simple Desk can not control the fixtures in it and raising and lower the dimmers shows nothing in Fixture Monitor 2D. However, if I switch to something like Functions or Virtual Console, the lights themselves work just fine and the monitor reflects the changes. At that point if I exit QLC, restart it and load 'workspace 2', then Simple Desk works fine again.
I can clearly live with this issue, but I'm a Newbie so I switch workspaces a lot depending on what I am trying to figure out.
QLC 4.12.1
Vista Home SP2 (do NOT laugh, it is my dedicated lighting and sound laptop)
![Smile :)](./images/smilies/icon_e_smile.gif)
uDMX
All fixtures are LED and the same in each workspace
Thanks
Jack