Q Light Controller+

Hi All,

I am just experimenting with using loopback to show the active state of a slider and for some reason can't assign an external input. I have tried a number of workspaces including some example ones I found in the forums.

Not sure what I have done wrong or it is a bug?

Attached is a brief movie of the situation.

Cheers
Mark

QLC+ 10.3.a
Mac OSX 10.11.3

Hello,

You selected a universe, you did not select a channel.

Thanks for the help, plugz

I thought I doing something wrong.

I had tried adding a channel number but it didn't work. I have since discovered you have to be quite careful when you add the channel number.

I had clicked off the line that has the channel number and that is when the trouble started!

I have attached another video to show the wrong way and then finally the correct way....

tip: You can create an Input Profile for this universe in the Input/Output tab, after this the channel selection may be easier.