3D Visualizer - Pan/Tilt movement speed
Posted: Thu Jan 25, 2024 4:43 pm
Hi,
Said it before. Wil say it again. The 3D visualizer is awesome!
Yet I found something that either can improve, or I'm just not aware how to fix it.
If I drag the pan/tilt channels for movers pretty fast from 0 to 255, the mover (e.g., default MAC 700 Wash) moves at a steady, but rather slower pace than what the fixture would actually be able to do in reality.
Channel 15 is defined as the pan/tilt speed channel, but I'm in the impression that this is not yet taken into account at this point.
Unfortunately my budget doesn't allow any Martin mover , but I tried it with my no-brand (that's a lie... SHEHDS) movers, and there it was even more visible in the tilt mode (maybe because these only are able to do 180° tilt). My mover was already seconds in place, while the visualizer still needed quite some time to get there. Note that pan seemed to be much closer to reality (540°).
There are most likely far more important things to look at first (completing missing functionalities), but just wanted to let you know (/ask some advice if it's my bad )
Thx,
Maarten
Said it before. Wil say it again. The 3D visualizer is awesome!
Yet I found something that either can improve, or I'm just not aware how to fix it.
If I drag the pan/tilt channels for movers pretty fast from 0 to 255, the mover (e.g., default MAC 700 Wash) moves at a steady, but rather slower pace than what the fixture would actually be able to do in reality.
Channel 15 is defined as the pan/tilt speed channel, but I'm in the impression that this is not yet taken into account at this point.
Unfortunately my budget doesn't allow any Martin mover , but I tried it with my no-brand (that's a lie... SHEHDS) movers, and there it was even more visible in the tilt mode (maybe because these only are able to do 180° tilt). My mover was already seconds in place, while the visualizer still needed quite some time to get there. Note that pan seemed to be much closer to reality (540°).
There are most likely far more important things to look at first (completing missing functionalities), but just wanted to let you know (/ask some advice if it's my bad )
Thx,
Maarten