QLC+ and Akai APC mini Brigthness
Posted: Wed Oct 25, 2023 4:08 pm
hello friends:
I am using Akai APC mini with QLC+.
At first the problem is that the brightness of the buttons is very low. So I was trying to find a solution.
In the input/output section I double clicked on AKAI and in the output section I set the channel to 7 and with that I managed to get the 64 buttons to show 100% brightness. Sadly this causes the square buttons on line 9 (right and bottom) to not show any light.
Then set the channel to 11 (Pulsing 1/2) and same issue.
I don't have enough knowledge to modify values in the AKAI Profile and I don't know if that would solve the problem.
I also found that the information in QLC+ help or forum was apparently outdated. Attach the comunication protocol APC mini pdf
I am using Akai APC mini with QLC+.
At first the problem is that the brightness of the buttons is very low. So I was trying to find a solution.
In the input/output section I double clicked on AKAI and in the output section I set the channel to 7 and with that I managed to get the 64 buttons to show 100% brightness. Sadly this causes the square buttons on line 9 (right and bottom) to not show any light.
Then set the channel to 11 (Pulsing 1/2) and same issue.
I don't have enough knowledge to modify values in the AKAI Profile and I don't know if that would solve the problem.
I also found that the information in QLC+ help or forum was apparently outdated. Attach the comunication protocol APC mini pdf