Q Light Controller+

Official forums of the QLC+ project
http://www.qlcplus.org/forum/

Hardware potentiometers / faders / encoders implementation

http://www.qlcplus.org/forum/viewtopic.php?t=16152

Page 1 of 1

Hardware potentiometers / faders / encoders implementation

Posted: Tue Feb 14, 2023 11:52 am
by unicque
Hej,

I learned about this software just a few minutes ago and I like it! Is there a easy way to implement hardware potentiometers / faders / encoders into the software? I would like to build a touchscreen kiosk with two integrated hardware thingies for master and 1 dimmer channel.

Re: Hardware potentiometers / faders / encoders implementation

Posted: Wed Feb 15, 2023 9:03 am
by GGGss
unicque wrote: ↑Tue Feb 14, 2023 11:52 am to implement hardware potentiometers / faders / encoders
You will minimally need a midi controller - there is no direct hardware connection possible (except the GPIO ports of the Raspberry Pi version).

Re: Hardware potentiometers / faders / encoders implementation

Posted: Wed Feb 15, 2023 9:20 am
by GGGss
unicque wrote: ↑Tue Feb 14, 2023 11:52 am Hej,

I learned about this software just a few minutes ago and I like it! Is there a easy way to implement hardware potentiometers / faders / encoders into the software? I would like to build a touchscreen kiosk with two integrated hardware thingies for master and 1 dimmer channel.
re-reading again, you talk about a touch screen... you can add a slider to the Virtual Console and this will be touchable...
All times are UTC
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited