Hello!
- I am testing the newest "QLC+ Raspberry Pi version 20190217". I have a question about whether you can change the the E1.31 priority on the rPi.
- I also installed the newest v4.12.1 on the Win10 PC for editing.
- When I was editing the project on the Win10 PC, I changed the priorities for U1, U2, U3, U4 to 95 according to the attached screenshot called "QLC_E1.31priority.png"
- Then I uploaded the project to the rPi2. (I even rebooted the rPi just to be safe).
- I had to manually change the rPi E1.31 output interface because it had defaulted to 127.0.0.1. I made sure it was the correct network that my monitoring PC was also on.
- I then used sACN view (on the Win10 pc) to look @ the traffic coming from the rPi/QLC (at the same time that Lightjams was also sending E1.31 data with priority 100). See the attached screenshot called "sACNviewPriorities.png" which shows that the QLC data is coming in with Priority=100 instead of the expected 95 that I had configured during the project editing session.
Let me know if this is supposed to work or if I am missing something. Thanks!
respect, frenchy (aka Steve French)
www.voltvision.com
Q Light Controller+
Official forums of the QLC+ project