Q Light Controller+

Hello Everybody,

I'm trying to Programm a Chaser for GPIO Pins. I can controll the Pins with the "Simple Desk" so the DMX Values and the Mapping in the Plugin works well.
But when I create Scenes for the Pins and put them Into a Chaser the Values of the Pins dont Change (I have tested it with the integrated "Monitor" Tool and with some LED's on the Pins).

How can i solve my Problem?

Thanks.

Can you attach your qxw file?
How do you start the chaser?

Hello,

i have attached the .qxw File.
I start the Chaser with a Button on the Virtual Console.

I still haven't fixed my Problem, any suggestions?

Thanks

It seems that if you enable fading in the channel properties dialog, then it works. I don't have explanation for this (yet).