I created a fixture definition which i can't load
Posted: Wed Feb 22, 2017 9:32 pm
Hi everyone,
I created this fixture definition (attached).
It's kind of complicated (like 5 channels of red, 5 of green, 5 of blue and 5 of White...) but i thought it was done.
If I import it on QLC+ I see no modes and it load it in 1 channel...
Someone can spot the problem?
I created this fixture definition (attached).
It's kind of complicated (like 5 channels of red, 5 of green, 5 of blue and 5 of White...) but i thought it was done.
If I import it on QLC+ I see no modes and it load it in 1 channel...
Someone can spot the problem?