Hi!
I've been using qlc+ for some time and also using it in clubs. I have not running into any problems exept this:
After running a show for a while the mouse is starting to slide away and it gets really hard to use it in a precise way. This is only when running qlc and if i go out of the program the mouse behaves normaly again. So my conclusion is that it's a bug. going into mouse settings on the computer and slowing it down helps a bit but doesn't take away the problem. I remember seeing a post about this a while ago but back then this wasn't my consern. I've now been looking for a long time and can't find anything about it. Maybe i'm blind or my searches are not good enough but i can't find a solution.
So please, point me in the right direction.
Thanks,
N.
Sliding cursor after running show for a while. (BUG)
-
- Posts: 376
- Joined: Thu Jun 17, 2021 9:31 am
- Location: Australia
- Real Name:
- Contact:
Hi,
What laptop are you using? I've seen this issue before with a trackpoint.
Send your specs and any other info that might help.
What laptop are you using? I've seen this issue before with a trackpoint.
Send your specs and any other info that might help.
- GGGss
- Posts: 2741
- Joined: Mon Sep 12, 2016 7:15 pm
- Location: Belgium
- Real Name: Fredje Gallon
A wandering mouse is mostly hardware related no? Underground, rate of reflection, laser, led or ball?
Does it wander always in the same direction?
[joke mode on] And you are living in what hemisphere? Your mouse might follow the rotation of the globe... [/mode off]
Really strange that it stops wandering when you stop QLC+. To my knowledge, QLC+ does not influence or set a mouse position.
Does it wander always in the same direction?
[joke mode on] And you are living in what hemisphere? Your mouse might follow the rotation of the globe... [/mode off]
Really strange that it stops wandering when you stop QLC+. To my knowledge, QLC+ does not influence or set a mouse position.
All electric machines work on smoke... when the smoke escapes... they don't work anymore