Hi everyone,
I would like to use my lights on qlc+ 5 in order to can see the 3D preview on my computer.
I can't find my Delibang led par on the software (at the moment i use a generic par with 8 dmx channel on qlc+).
Can someone help me?
I will also enclose the fixture manual of the par.
Delibang par
-
- Posts: 5
- Joined: Fri Jan 27, 2023 3:40 pm
- Real Name: Luca Rota
- Attachments
-
- Fixture's manual.zip
- (1.52 MiB) Downloaded 63 times
-
- Posts: 371
- Joined: Thu Jun 17, 2021 9:31 am
- Location: Australia
- Real Name:
- Contact:
Thanks for the info, I'll take a look at this asap.
-
- Posts: 371
- Joined: Thu Jun 17, 2021 9:31 am
- Location: Australia
- Real Name:
- Contact:
Hi there,
I'm not going to post this on the fixture definitions page because I don't understand Alias'.
But here is the fixture profile I've made for your light.
I got the lumens using a pretty dodgy calculation method (see pics). Let me know how this goes.
Make sure you save the fixture in the proper directory. (If on windows it's C:\Users\[YOURNAME]\QLC+\fixtures\)
I'm not going to post this on the fixture definitions page because I don't understand Alias'.
But here is the fixture profile I've made for your light.
I got the lumens using a pretty dodgy calculation method (see pics). Let me know how this goes.
Make sure you save the fixture in the proper directory. (If on windows it's C:\Users\[YOURNAME]\QLC+\fixtures\)
-
- Posts: 371
- Joined: Thu Jun 17, 2021 9:31 am
- Location: Australia
- Real Name:
- Contact:
Just note that the 'strobe speed' channel effects the 'program' that is selected.