Hello, everyone,
Today I received the DMX interface from Bitwizard (the board does not have the FT245RL chip on board) and tried every manual that is available on the internet. I didn't make it. I have now reloaded the image. Can you please show me a current tutorial?
Bitwizard
-
mcallegari
- Posts: 4683
- Joined: Sun Apr 12, 2015 9:09 am
- Location: Italy
- Real Name: Massimo Callegari
- Contact:
-
djtale2003
- Posts: 10
- Joined: Wed Jul 01, 2020 5:56 pm
- Real Name: Dirk Rehlinghaus
hello massimo,
many thanks for the quick response. I have tried to follow these instructions, but I do not understand why I should install qlc again when I have installed an image that was ready before you? The link for Harold van Hulten's howo is also no longer available. Do I even need OLA for the bitwizard?
many thanks for the quick response. I have tried to follow these instructions, but I do not understand why I should install qlc again when I have installed an image that was ready before you? The link for Harold van Hulten's howo is also no longer available. Do I even need OLA for the bitwizard?
-
mcallegari
- Posts: 4683
- Joined: Sun Apr 12, 2015 9:09 am
- Location: Italy
- Real Name: Massimo Callegari
- Contact:
there is some notes in the official image PDF about bitwizard.
No help from there?
No help from there?
-
djtale2003
- Posts: 10
- Joined: Wed Jul 01, 2020 5:56 pm
- Real Name: Dirk Rehlinghaus
in the description there is a link, but it is invalid. Which PDF do you mean?
-
mcallegari
- Posts: 4683
- Joined: Sun Apr 12, 2015 9:09 am
- Location: Italy
- Real Name: Massimo Callegari
- Contact:
The PDF provided with the official QLC+ on the raspberry pi image
-
djtale2003
- Posts: 10
- Joined: Wed Jul 01, 2020 5:56 pm
- Real Name: Dirk Rehlinghaus
Hi there,
I have no idea what I've done now, but it works after the 5th time uploading the image.
Thanks for the support
I have no idea what I've done now, but it works after the 5th time uploading the image.
Thanks for the support
-
GGGss
- Posts: 3014
- Joined: Mon Sep 12, 2016 7:15 pm
- Location: Belgium
- Real Name: Fredje Gallon
By default, Bitwizard uses its XLR as an input (not output).
Did you instruct the Pi to set a high value to the GPIO output as needed?
Did you instruct the Pi to set a high value to the GPIO output as needed?
All electric machines work on smoke... when the smoke escapes... they don't work anymore