We have problems after reboot, when windos system shut down and lost power.
It does not load the showfile properly
There are three error variants:
upper picture -
it does not set the rake on output for Artnet - 2.x.x.x IP
Lower picture -
If the missing outputs are completely empty and there is nothing in the window
The picture below shows a 0 instead of artnet universe 8
These are always and everywhere the same 3 mistakes.
Either you simply restart the program (not pc restart) or you reset the settings and save it in the folder c - dmx
In most cases a program restart is sufficient.
the problem occurs in all 10 systems at irregular intervals.
would great to get help
thanks a lot