Can't assign External Input

Archive of the non-categorized posts related to the QLC+ technical support.
Please do not create new threads here, instead, use the categories above !
Post Reply
mlohrey
Posts: 243
Joined: Mon Apr 20, 2015 5:07 am
Real Name: Mark Lohrey

Hi All,

I am just experimenting with using loopback to show the active state of a slider and for some reason can't assign an external input. I have tried a number of workspaces including some example ones I found in the forums.

Not sure what I have done wrong or it is a bug?

Attached is a brief movie of the situation.

Cheers
Mark

QLC+ 10.3.a
Mac OSX 10.11.3
Attachments
loopback error.mp4.zip
(217.18 KiB) Downloaded 61 times
plugz
Posts: 637
Joined: Sun Apr 12, 2015 6:30 pm
Real Name: David

Hello,

You selected a universe, you did not select a channel.
mlohrey
Posts: 243
Joined: Mon Apr 20, 2015 5:07 am
Real Name: Mark Lohrey

Thanks for the help, plugz

I thought I doing something wrong.

I had tried adding a channel number but it didn't work. I have since discovered you have to be quite careful when you add the channel number.

I had clicked off the line that has the channel number and that is when the trouble started!

I have attached another video to show the wrong way and then finally the correct way.... ;-)
Attachments
correct way.mp4.zip
(822.28 KiB) Downloaded 68 times
plugz
Posts: 637
Joined: Sun Apr 12, 2015 6:30 pm
Real Name: David

tip: You can create an Input Profile for this universe in the Input/Output tab, after this the channel selection may be easier.
Post Reply