pixel archs

Ask a generic question about the usage of QLC+, not related to a particular operating system
Post Reply
Krsound
Posts: 141
Joined: Sun May 31, 2015 4:42 am
Location: USA
Real Name: Kyle Sims
Contact:

Hello I am having a issue with my pixel arches its a 100 pixel arch using 2811 strips these are brand new strips. At first i thought it was cabling but i am running these from a pixlit 16 which has a test mode built into its firmware and they ran fine, then i though networking since there ran with e1.31 so i downloaded jinx and they run flawlessly so i am unsure why qlc is having issue running them. Oh the issue its having is stuttering between matrix steps if you put a solid color they delay to turn on then it seems like it resets because in solid color there on then they turn off after about 30 seconds then come back on. also i have a larger matrix about 450 pixels with the pixlite 16 e1.31 and they run just fine with qlc. Help
Krsound
Posts: 141
Joined: Sun May 31, 2015 4:42 am
Location: USA
Real Name: Kyle Sims
Contact:

i have attach the the qlc file. i started a new qlc file and they work just fine so its something with my large show
Attachments
show.qxw
(1.13 MiB) Downloaded 35 times
Post Reply