Q Light Controller+

Hi all,

I was hoping for a feature where a flash button could temporarily over write the values of fixtures that are currently in place from a toggle button. For example,if there is a toggle button that has a dimmer at 107 but then a flash button temporarily changes it to 50 for example. Currently it would only work if the value in the flash button is higher than that in the toggle button

Hi, what you described is exactly the behavior expected for HTP channels.
Modifying this would be breaking HTP, so I don't think this will ever be implemented.
If you know what you're doing, you can force those channels to be LTP instead.

Hi,

Thank you for the speedy reply. Should I change the RGB channels from HTP to LTP?

Hi,

Changed the channels to LTP and it does exactly what I need! Thank you for the info.

Hi,

Turns out the LTP doesn't work perfectly since it doesn't default the channel values to 0 and it breaks use of submasters with a cue list. Do you have any idea what I can do to solve this?